(1) All portions of the saw blade shall be enclosed or guarded, except for the working portion of the blade between the bottom of the guide rolls and the table. (63) Authorized person means one to whom the authority and responsibility to perform a specific assignment has been given by the employer. (iv) The Inch operating means shall be designed to prevent exposure of the workers hands within the point of operation by: (a) Requiring the concurrent use of both hands to actuate the clutch, or. If the deficiencies are not corrected, OSHA may revoke recognition, effective in 60 days, unless the validation organization requests a hearing within that time. 1910.1000 Air contaminants. (1) Collars. The failure shall be detectable by a simple test, or indicated by the control system. The third-party validation organization, the validating laboratory, and the employees of each shall meet the requirements set forth in this section of this appendix. Similarly, only presses with a configuration such that a person's body cannot completely enter the bed area are approved for PSDI. (1) Feed rolls and saws shall be protected by a hood or guard to prevent the hands of the operator from coming in contact with the in-running rolls at any point. Regulations Respecting Occupational Health and Safety, Decree 885-2001, 5-2.1, r.19.01, July 2001. 1. (i) Tables O-4 and O-6 and Figures O-30 and O-32 show minimum dimensions for straight relieved and unrelieved flanges for use with wheels with small holes that fit directly on the machine spindle. (c) Safeguarding the point of operation -. Demonstration of a thorough inspection of the entire press and PSDI safety system to ascertain that the installation, components and safeguarding have not been changed, modified or tampered with since the installation certification/validation or last recertification/revalidation was made. Workers who operate and maintain machinery suffer approximately 18,000 amputations, lacerations, crushing injuries, abrasions, and over 800 deaths per year. Blocks or wedges shall be made of material the strength and construction of which should meet or exceed the specifications and dimensions shown in Table O-11. (4) Any automatic cutoff saw that strokes continuously without the operator being able to control each stroke shall not be used. This monitor shall stop slide motion and prevent successive press strokes if decoupling occurs, or if the monitor itself fails. When required by paragraph (c)(5) of this section, the brake monitor shall meet the following requirements: (i) Be so constructed as to automatically prevent the activation of a successive stroke if the stopping time or braking distance deteriorates to a point where the safety distance being utilized does not meet the requirements set forth in paragraph (c)(3)(iii)(e) or (c)(3)(vii)(c) of this section. 2. Only part revolution type mechanical power presses are approved for PSDI. It is recommended, however, that no projecting setscrews or oilcups be used in any revolving pulley or part of machinery. 1910.97 Nonionizing radiation. 1910.147 The control of hazardous energy (lockout/tagout). Bearings shall be kept in alignment and properly adjusted. 1 For wheels under 114 inches thick F dimension shall not exceed 40 percent of wheel thickness. ), (8) Top grinding. No changes found for this content after 1/03/2017. (7) Driving flange. Class 20. (iv) Personal protective equipment (gloves, goggles, aprons, and other items) shall be worn.
Dhi Mortgage Down Payment Assistance, Articles O